Posted: 4/23/12
Event: Trail Buster Challenge
Where: 208 Bemis Rd. Fitchburg, MA 014220
When: April 28, 2012
Classes: 1.9 scale , 2.2 unlimited
Entry fee: $15
Contact: 978.342.3374
Rules:
Modified (1.9 scale)
This class is for the typical trail rigs, that you have modified quite a bit for off road. You would most likely " TRAILER " these to the trailhead.
* Vehicle is limited to 1.9 inch wheels/rims or smaller at the bead surface.
* All 1.9" OEM tires are legal, any modified tire may only be 6" tall
* Track width can be NO more than 12.5"
* Vehicles are limited to 1 ESC only
* Vehicles are limited to 1 motor powering both of the axles
* Vehicle battery must be mounted on the chassis.
* Vehicles are limited to 2-wheel steering only.
* No 4 wheel steer or rear steer
* No "DIG" of any kind is allowed.
Bodied vehicles:
* 1/8th or 1/10th bodies that should resemble its original form.
* Wheelbase to match body's intended wheelbase, up to a 1.5" allowed difference, maximum wheelbase of 13.75"
* Full frame chassis only, Chassis minimum length to be no less than the corresponding wheelbase
Bodiless vehicles:
* Bodiless vehicles must resemble a 1:1 vehicle to include hood & grille ( Jeep, FJ40 etc)
* Wheelbase to match chassis intended wheelbase, up to a 1.5" allowed difference, maximum wheelbase of 13.75"
* 1/8th or 1/10th scale tuber that must be a self-supporting, structurally complete, rigid frame as long as the intended wheel base
---------------------------------------------------------------------------------------------------------------------------------------------------------------
Unlimited (2.2 scale)
This class is for the typical trail rigs, that you have modified quite a bit for off road. You would most likely " TRAILER " these to the trailhead. Similar to the modified class but with even less restrictions.
* Vehicle is limited to 2.2" wheels/rims or smaller at the bead surface.
* All 2.2" OEM tires are legal, any modified tire may only be 6" tall
* No limit on track width
* Vehicles are limited to 1 ESC only
* Vehicles are limited to 1 motor powering both of the axles
* Vehicle battery must be mounted on the chassis.
Bodied vehicles:
* 1/8th or 1/10th bodies that should resemble its original form.
* Wheelbase to match body's intended wheelbase, up to a 2.75" allowed difference, maximum wheelbase of 13". Centerline of axle must fall within factory wheelwell openings.
* Full frame chassis only, Chassis minimum length to be no less than the corresponding wheelbase
Bodiless vehicles:
* Bodiless vehicles must resemble a 1:1 vehicle to include hood & grille ( Jeep, FJ40 etc)
* Wheelbase to match chassis intended wheelbase, up to a 1.5" allowed difference, maximum wheelbase of 13.75"
* Chassis length must be as long as vehicles wheelbase.
* 1/8th or 1/10th scale tuber that must be a self-supporting, structurally complete, rigid frame as long as the intended wheel base
For more information follow the forum at RCExcitment.
