Posted: 11/5/14
So you just picked up your Yeti XL and are ready to go bashing! Take a few moments to check out some recommendations to make sure you have the best experience possible.
Pre-run checklist:
Check the screw tightness, especially around the front bulkhead
Wheel nuts – We recommend using a ratchet with an 8mm socket to install and remove the wheel nuts; this is easier on the hands than the included wrench.
Battery install – Your Yeti XL comes with foam spacers for using two 2S batteries or two 3S batteries. You can run your batteries with their leads exiting the front of the tray or the rear of the tray
If using standard hard case 2S batteries, use the long skinny foams on top or bottom, and the block foam in front or back. We prefer rear battery lead exit and rear battery placement with the foam on top to keep the weight as low and back as far as possible.
If using standard 3S batteries, store the long skinny foams and just use the block foam to keep the battery from moving front to rear tugging on the leads.
Trimming the tabs slightly that hold the battery doors closed may help with large batteries. Using a small x-acto knife, you can cut a small amount of plastic out to make sliding the pins in on the battery doors much easier.
When unleashing the massive amount of power this rig has to offer, it is possible to rip the tires from the wheels, especially if they did not get fully glued from the factory. It is highly recommended to make sure the tires are fully glued before running. Using your fingers, tug on the tires all the way around all the wheels and make sure they are fully attached.
Check screw shafts on transmission outputs
Check wiring for proper routing (should be away from any moving parts) and for any loose connections.
Before using your new rig, buy the wife/GF something nice because you won’t be spending much time with her once you unleash the Yeti XL. (This last one is probably the most important). Clicking here is a good start.
If for some reason you disregarded that last piece of advice, or happened to read this blog after the fact, you may be forced to buy one of these.....
If you are a girl and purchased the Yeti XL, reverse this process as us guys are cheap and expect cubic zirconium's laid in titanium bands.
Please make sure to check back regularly for the latest information and tips! As always thank you for your support!
